Laser Cut and Engraved Moon for Trial and Error

June 28, 2018

I created this moon for one of the niches in the piece.  It is engraved in 1/8" mdf and is around 3.5" in diameter. The settings were at 500mm/sec and around 20% power for any K40 people out there. I struggled a little bit to cut it completely through. I think that is a focusing issue and am a few mm out of focus, but it still works pretty well.  I was able to "pop" it out of the mdf, but one part of the edge was fuzzy.

 

Please reload

Featured Posts

K40 Laser - Entry 11: Exhaust Modification 2

December 12, 2017

1/10
Please reload

Recent Posts
Please reload

Archive