K40 Laser - Entry 3: Quality Control Part 1

November 20, 2017

Did I say quality control?  I ran into my next nuance with the K40 - While trying to peel the paper protective tape on the window.  I needed to remove the plexiglass from the 4 screw post that hold it into place. Well, it was drilled so off center that it cracked when trying to remove it.  I temporarily superglued it back together until I could replace it.

If cracking it was the bad news, the good news was when I contacted the seller they refunded me $20 for my trouble, and to top it off, TAP plastics in Bellevue GAVE me replacement acrylic. Sure it was just a piece of off cut from the remnants bin, but props to them!

 

With that said, I added a boss piece of smoke gray tinted acrylic, replacing the standard orange. Looks and works great.

 

Please reload

Featured Posts

K40 Laser - Entry 11: Exhaust Modification 2

December 12, 2017

1/10
Please reload

Recent Posts
Please reload

Archive