November 28, 2017

An old Claremont Graduate University friend, David Collis has a show of new paintings at The Artful Space in Oro Valley Arizona.  Check it out if you're down that way.

November 22, 2017

When purchasing this K40 laser cutter, it became apparent that I would need a computer to drive it since really don't have an extra laying around. We're more of a Mac family and the unit is PC only out of the box.  There are some modifications to make one Mac friendly but they sounded too complicated for me at this time. 

After some research, it was apparent that it might actually be easier to set up an older machine.  After weighing the pros and cons, I d...

November 21, 2017

7 years of bad luck? A broken mirror., Rather heat-shattered mirror

Lesson 2 in quality control, stock K40 units ship with notoriously cheap mirrors.  This one cracked the first time I set the power up above 20%.  I think I had it up around 60% as I was attempting one of my first real cuts.  I heard a pop and thought it might be the tube.  Fortunately it was just an inexpensive mirror.

I got onto eBay and Amazon and after a little research, I foun...

November 20, 2017

There are 3 mirrors each situated at approximately 45 degrees to one another that reflect the beam from the laser tube to the lens and the to the material to be cut or engraved.  It is necessary to align or "focus" them.   I had hope that my unit was aligned well enough to use right out of the box, as many are on delivery, but sadly I was disappointed and needed to learn to do it myself.

Focusing involves putting a piece of masking tape or similar material...

November 20, 2017

Did I say quality control?  I ran into my next nuance with the K40 - While trying to peel the paper protective tape on the window.  I needed to remove the plexiglass from the 4 screw post that hold it into place. Well, it was drilled so off center that it cracked when trying to remove it.  I temporarily superglued it back together until I could replace it.

If cracking it was the bad news, the good news was when I contacted the seller they refunded me...

November 15, 2017

 Mike Oday is the featured artist for November at Lynn Hanson Gallery in Pioneer Square. As you can see from the featured image, he creates whimsical work.  Both paintings and ceramics.  I still have a trio of works showing there as well.

November 15, 2017

I have initially placed the laser on my cluttered painting/work table.  This will have to do until I find/build a cart/table that will work better. It is close to a window for easy access for the exhaust plumbing.

 One reason for waiting so long to purchase one was the upgrade to digital controls. Older systems have a dial instead of the digital controller. I figured this might last longer.

Here's everything packed inside.  The exhaust fan on the top, the blue t...

November 12, 2017

After some life changes recently it is time to get back to work on art.  A laser cutter/engraver has been a valuable tool in the creating of my work.  I purchased an infamous K40 laser on eBay a few weeks ago.  Just unpacking it here.

The good news is that is that it did arrive in good condition.  Nothing broken or damaged.  This laser cutter has been around for probably 8-10 years in one form or another.  Early units had notoriously poor quality con...

Please reload

Featured Posts

K40 Laser - Entry 11: Exhaust Modification 2

December 12, 2017

1/10
Please reload

Recent Posts
Please reload

Archive